Place a check in the boxes for any software you would like to install. Select Execute to perform a test print, if desired. Select Next.Īfter the MP Drivers for the printer have been downloaded and installed (this may take several minutes), the Print Head Alignment Recommended screen will appear. If your PC is connected to a VPN (Virtual Private Network), temporarily disconnect from the VPN and try the setup again. Also, if you are using a dual-band router, further troubleshooting information can be found here. Also, you may need to temporarily disable any firewall software, or you may need to open blocked ports in the firewall. If your printer is not detected, make sure that the computer has reconnected to the correct network. It will then communicate directly with the printer, sending it the information it needs to connect to your wireless router. Your computer will temporarily disconnect from your wireless network. When the Printers on Network List screen appears, make sure that your printer is selected (shown by a check in the box on the left), then select Next. Select Next.The installer will search for network printers. Select Connect via wireless router (recommended), then select Next. Select Wireless LAN Connection, then select Next. Select Next when prompted to allow all Install Wizard processes. Read the information regarding the Extended Survey Program. If you select No, the installation will not proceed. Read the License Agreement, then select Yes to proceed. When this screen appears, select your place of residence, then select Next. If you are asked to provide permission to run the file, select Yes or the appropriate affirmative option. Open the file when the download has finished. When the Wi-Fi lamp (D) flashes quickly, the printer is ready to receive information from the wireless network.įollow these steps to set up the computer to communicate wirelessly with the printer. Make sure that the Wi-Fi lamp (D) flashes quickly and the ON lamp is lit. Press the Color button (C), then the Wi-Fi button (A). Press and hold the Wi-Fi button (A) on the printer until the ON lamp (B) flashes. : New firmware version 1.0.5.Follow these steps to complete a wireless setup which enables you to operate the PIXMA printer from a Windows computer. : Canon EOS R5 C training series is released. Perform the wireless setup one more time. Once the router is plugged back it, after approximately 2 minutes all devices should be back up on the network. If the setup fails, please unplug your router for approximately 1 minute.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |